Carpentry & Woodworking

               Figure 8                                                            Figure 9

               Figure 10                                                            Figure 11

               Figure 12                                                            Figure 13

               Figure 14                                                            Figure 15

NOTE: COMPLETE ONE OPENING AT A TIME.

Apply pressure sensitive veneer or laminate to the inside face frame edge
Inside Face Frame Edge
- Cut veneer or laminate to length to fit inside edge of stile. Width of veneer/laminate strip should allow for trimming flush with stile after installation.
- Peel back just enough backing from the top of the strip to anchor the strip to the inside edge of the face frame.
- Make sure the top edge of the strip is flush and square with the top of the face frame opening.
- Then press and lightly smooth downward, peeling the backing off as you go. (Be very careful to get it lined up right the first time, because the special adhesive makes it very difficult to get off!)
- After applying veneer/laminate to inside edge of stiles, cut veneer or laminate to length to fit inside edge of rail. repeat application steps above.
- On bottom rail, match bottom rail's inside edge when applying the veneer or laminate, because you will not be able to easily trim this edge.

Tools you'll need for this project

FIND HELP FOR THIS PROJECT

Free catalog